Mitsubishi Outlander PHEV 2019 Manual page 237

Power switch
ACC
Electrical devices such as the audio and ac-
cessory socket can be operated. Can be used
when the Ready indicator is off.
The indication lamp on the power switch illu-
minates orange.
ON
All vehicle's electrical devices can be operat-
ed.
7
The indication lamp on the power switch illu-
minates blue. The indication lamp goes off
when the Plug-in Hybrid EV System is oper-
ating.
NOTE
l Your vehicle is equipped with an electronic
immobilizer.
To start the Plug-in Hybrid EV System, the
ID code which the transponder inside the
key sends, must match the one registered in
the immobilizer computer. Refer to "Elec-
tronic immobilizer (Anti-theft starting sys-
tem)" on page 4-03.
7-12 Starting and driving
Changing the operation mode
E00631901559
If you press the power switch without de-
pressing the brake pedal, you can change the
operation mode in the order of OFF, ACC,
ON, OFF.
CAUTION
l When the Plug-in Hybrid EV System is not
operating, put the operation mode in OFF.
Leaving the operation mode in ON or ACC
for a long time when the Plug-in Hybrid EV
System is not operating may cause the auxil-
iary battery to discharge, making it impossi-
ble to start the Plug-in Hybrid EV System.
OGGE19E1
CAUTION
l When the auxiliary battery is disconnected,
the current operation mode is memorized.
After reconnecting the auxiliary battery, the
memorized mode is selected automatically.
Before disconnecting the auxiliary battery
for repair or replacement, make sure to put
the operation mode in OFF.
Be careful if you are not sure which opera-
tion mode the vehicle is in when the auxili-
ary battery is run down.
l The operation mode cannot be changed from
OFF to ACC or ON if the keyless operation
key is not detected to be in the vehicle. Refer
to "Keyless operation system: Operating
range for starting the Plug-in Hybrid EV
System and changing the operation mode"
on page 4-08.
NOTE
l If the operation mode cannot be changed to
OFF, perform the following procedure.
1 Press the electrical parking switch
. and lock the wheels, then change the
operation mode to OFF.
2 One of the other causes could be low
. auxiliary battery voltage. If this oc-
curs, the keyless entry system and
keyless operation will also not oper-
ate.
Contact a MITSUBISHI MOTORS Author-
ized Service Point.