Mitsubishi Outlander PHEV 2019 Manual page 314

How to operate the LDW
E00635801325
The indication on the information screen of
the multi-information display changes as fol-
lows depending on the state of the system.
To turn on/off the LDW
NOTE
l The LDW is turned on when the vehicle is
shipped from the factory.
l
The currently selected LDW setting (on or
off) is stored even when the operation mode
of the power switch is put in OFF.
To turn on the LDW, press the LDW switch.
The "LDW" indicator will appear on the in-
formation screen of the multi information
display and the system is placed in the 'ON
state'.
To turn off the LDW, press the LDW switch.
The "LDW" indicator on the information
screen of the multi information display will
then go out and the system is placed in the
'OFF state'.
To return the LDW to the 'ON state', press
the LDW switch again.
OGGE19E1
Lane Departure Warning (LDW)*
Standby state
In the standby mode, the system is capable of
recognizing the lane in which your vehicle is
positioned and issuing audible warning when
your vehicle goes out of the lane.
The system automatically shifts from the
'ON state' to the 'standby state' if all of the
following conditions are simultaneously met.
The "LDW" indicator in the information dis-
play changes to indicator (green).
l The vehicle speed is approximately
65 km/h (40 mph) or higher.
l The turn-signal lever is not operated.
l The hazard lamp is not activated.
l Environmental conditions are adequate
for the system to recognize the lane
markings on both sides.
l
The system has been placed in the 'ON
state'.
Starting and driving
7
7-89