Charging Troubleshooting Guide - Mitsubishi Outlander PHEV 2019 Manual

2019 mitsubishi outlander phev manual
Hide thumbs Also See for Outlander PHEV 2019:
Table of Contents

Advertisement

Charging troubleshooting guide

Charging troubleshooting guide
Symptom
3
Charging cannot be
The operation mode of the power
started.
switch is in the "ON" position.
The drive battery is already fully
charged.
The temperature of the drive bat-
tery is too high or too low to
charge.
The auxiliary battery is dis-
charged.
The vehicle or the charging cable
has a malfunction.
Normal charging can-
There is no electrical power com-
not be started.
ing from the outlet.
The charge connector is not con-
nected correctly.
The charge connector was connec-
ted and disconnected repeatedly in
a short time.
3-28
Charging
Possible cause
Put the operation mode of the power switch in "OFF" before charging.
Charging cannot be performed if the drive battery is already fully charged. Charg-
ing automatically turns off if the drive battery is fully charged.
Confirm the drive battery temperature.
Refer to "Cautions and actions to deal with intense heat" on page 2-10 and "Cau-
tions and actions to deal with intense cold" on page 2-10.
The drive battery cannot be charged if the vehicle electrical systems cannot be
turned on. If the auxiliary battery is discharged, charge or emergency start the aux-
iliary battery.
Refer to "Emergency starting" on page 9-02.
The vehicle or charging cable may have a malfunction. Confirm if the warning
lamp on the meter is illuminated. Confirm if the indicator on the control box is in-
dicating a malfunction. If a warning is displayed, stop charging and contact a
MITSUBISHI MOTORS Authorized Service Point.
Confirm that there has not been a power failure. Make sure the breaker is on. If an
outlet with a timer device installed is used, power will only be available at the time
set by the timer.
Confirm if the POWER indicator on the control box is illuminated.
Confirm the charge connector is connected correctly.
Disconnect the charge connector, wait for a while, then start charging procedure
again from the beginning.
OGGE19E1
Possible solution
E08301501243

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents