Keyless Operation System - Mitsubishi Outlander PHEV 2019 Manual

Keyless operation system

NOTE
l You may purchase a replacement battery at
an electric appliance store.
l A MITSUBISHI MOTORS Authorized
Service Point can replace the battery for you
4 if you prefer.
1. Remove the emergency key from the
key.
Refer to "Emergency key" on page
4-14.
2. With the MITSUBISHI mark facing you,
insert the cloth covered tip of a straight
blade (or minus) screwdriver into the
notch in the remote control switch case
and use it to open the case.
4-06 Locking and unlocking
NOTE
l Be sure to perform the procedure with the
MITSUBISHI mark facing you. If the
MITSUBISHI mark is not facing you when
you open the remote control switch case, the
transmitter may come out.
3. Remove the old battery.
4. Install a new battery with the + side (A)
up.
+ side
- side
Coin type battery
CR2032
5. Close the case firmly.
6. Install the emergency key removed in
step 1.
7. Check the keyless operation function to
see that it works.
OGGE19E1
Keyless operation system
E00305602432
The keyless operation system allows you to
lock and unlock the doors and tailgate and
start the Plug-in Hybrid EV System simply
by carrying the keyless operation key with
you.
The keyless operation key can also be used as
the keyless entry system remote control
switch.
Refer to "Keyless entry system" on page
4-03.
The driver should always carry the keyless
operation key. This key is necessary for lock-
ing and unlocking the doors and tailgate,
starting the Plug-in Hybrid EV System and
otherwise operating the vehicle, so before
locking and leaving the vehicle, be sure to
check that you have the keyless operation
key.
WARNING
l
People with implantable cardiac pace-
makers or implantable cardiovascular-de-
fibrillators should not go near the exterior
transmitters (A) or the interior transmit-
ters (B). The radio waves used by the key-
less operation system could adversely af-
fect implantable cardiac pacemakers or
implantable cardiovascular-defibrillators.