Mitsubishi Outlander PHEV 2019 Manual page 207

Combination headlamps and dipper switch
NOTE
l The sensitivity of the automatic on/off con-
trol can be adjusted. For further information,
contact a MITSUBISHI MOTORS Author-
ized Service Point.
On vehicles equipped with the Smartphone
Link Display Audio or the MITSUBISHI
Multi-Communication System
screen operations can be used to make the
6 adjustment.
Refer to the separate owner's manual for de-
tails.
l When the headlamps are turned off by the
automatic on/off control with the operation
mode in ON, the front fog lamps and rear
fog lamps also go off. When the headlamps
are subsequently turned back on by the auto-
matic on/off control, the front fog lamps also
come on but the rear fog lamp stays off. If
you wish to turn the rear fog lamp back on,
operate the switch again.
l Do not cover the sensor (A) for the automat-
ic on/off control by affixing a sticker or label
to the windscreen.
6-60 Instruments and controls
NOTE
l If the lamps do not turn on or off with the
switch in the "AUTO" position, manually
operate the switch and we recommend you
to have your vehicle checked.
Lamps (headlamps, fog lamps,
(MMCS),
etc.) auto-cutout function
l
If the operation mode of the power
switch is put in OFF or ACC while the
lamp switch is in the "
lamps will turn off automatically when
the driver's door is opened.
l If the operation mode of the power
switch is put in OFF or ACC while the
lamp switch is in the "
lamps will remain on for about 3 mi-
nutes while the driver's door is shut and
will then automatically turn off.
NOTE
l The lamp auto-cutout will not function when
the lamp switch is in the "
OGGE19E1
NOTE
l The lamp auto-cutout function can also be
disabled.
For further information, we recommend you
to consult a MITSUBISHI MOTORS Au-
thorized Service Point.
On vehicles equipped with the Smartphone
Link Display Audio or the MITSUBISHI
Multi-Communication
screen operations can be used to make the
adjustment. Refer to the separate owner's
manual for details.
" position, the
When you want to keep the
lamps on:
1. Turn the lamp switch in the "OFF" posi-
tion while the operation mode of the
" position, the
power switch is in OFF or ACC.
2. Turn on the lamps with the switch in the
"" or ""
lamps will remain on.
" position.
System (MMCS),
position again, then the