Mitsubishi Outlander PHEV 2019 Manual page 423

220-240 V AC power supplies*
WARNING
l Do not let children touch the 220-240 V
AC power supply.
l The cooling fan in the engine compart-
ment may automatically operate when us-
ing the 220-240 V AC power supply. Keep
your hands and clothes away from the
cooling fan.
l
Never use the 220-240 V AC power supply
when lightning or thunder is observed or
expected.
l Never use the 220-240 V AC power supply
for electromedical apparatus.
8
CAUTION
l When the 220-240 V AC power supply is
not in use, be sure to cancel power supply by
pressing the 220-240 V AC power supply
switch, disconnect the plug and close the lid.
This will prevent the 220-240 V AC power
supply from becoming clogged and short cir-
cuiting.
l Do not stand behind the exhaust pipe as the
engine may automatically start depending on
the condition. Heat from the exhaust could
lead to burns.
l Make sure that the plug is inserted all the
way into the 220-240 V AC power supply
before using an electrical appliance.
l Do not use an electrical appliance in the ve-
hicle which emits heat such as a heater. Heat
damage to interior parts could result.
8-78 For pleasant driving
CAUTION
l Do not connect a malfunctioning electrical
appliance to the 220-240 V AC power sup-
ply. Doing so could damage the 220-240 V
AC power supply.
NOTE
l The accessory socket and 220-240 V AC
power supplies can be used simultaneously.
Refer to "Accessory socket*" on page 8-75.
l If the plug of the electrical appliance was
loose or wobbled when inserted in the outlet,
have the 220-240 V AC power supply re-
placed at a MITSUBISHI MOTORS Author-
ized Service Point.
l Never leave the vehicle, perform refueling
or washing the vehicle while using the
220-240 V AC power supply.
l You may hear operating sounds such as
sounds from the cooling fan near the lug-
gage area when using the 220-240 V AC
power supply. This is normal.
l Never use electrical appliance that is vulner-
able to vibration or heat in the cabin. When
exposed to strong direct sunlight, the cabin
will become extremely hot. It could cause
product failure.
l
Do not use the 220-240 V AC power supply
with the vehicle covered by a car cover.
l When closing the window, door or tailgate,
be careful not to trap the power supply cord.
l 220-240 V AC power supply cannot be used
in the following cases.
OGGE19E1
NOTE
• When the Plug-in Hybrid EV System
warning lamp is illuminated.
• When the drive battery level display indi-
cates 0.
• When the "PROPULSION POWER IS
REDUCED" warning display appears.
l Electrical appliance may not operate normal-
ly or electricity supply stops under the fol-
lowing conditions. You may hear an opera-
tion noise. This is normal.
• When the power consumption of the elec-
trical appliance exceeds 1500 W.
• When the vehicle interior temperature is
too hot or too cold.
l When the 220-240 V AC power supply can-
not be used or is not returned to operation
automatically after stopping electricity sup-
ply, follow the procedures below.
1 Disconnect the plug of electrical ap-
. pliance.
2 Confirm the remaining quantity of
. the drive battery. When it is low,
charge the drive battery by using the
battery SAVE/CHARGE mode
switch, etc.
"Battery SAVE/CHARGE mode
switch" on page 7-28
Normal charging (charging method
with rated AC 220-240V outlet)
® p. 3-10
Quick charging (charging method
with quick charger) ® p. 3-17