D-Channel Configuration - Avaya Communication Server 1000 Installation And Commissioning Manual

D-channel configuration

Table 19: PRI/NI2 D-channel interface configuration (LD 17)
Euro D-channel interface configuration (LD 17)
configuration in LD 17 needed to support PRI/NI2 and PRI2/EURO D-channel interfaces.
The example given in the tables is specific to EURO and NI2 interfaces. However, PRI D-
channel in the PRI Gateway is also supported on other interface types as well.
For CTYP=MSDL configuration, CS 1000 software is flexible. An E1/T1 span can use port 0
or port 1 of the DDCH along with MG_CARD prompt added to support the Media Gateway
Controller (MGC).
Backup D-channels are supported. Use the CLI to configure backup D-channels in the same
manner as the primary D-channels.
Important:
If configuring the NTBK51AA dual D-channel daughterboard on a MG 1000E PRI Gateway,
do not configure port 0 as the backup D-channel. This generates a SCH4765 error message
and causes the configuration build to fail. You must configure backup D-channels on port 1
of the D-channel daughterboard.
Important:
For the PRI Gateway, the following software package for the functionality that allows the use
of port 0 or port 1 is provided in CS 1000 Extended Media Gateway PRI (MGP) package
418
Media Gateway 1000E PRI Gateway Installation and Commissioning
Prompt Response
TYPE CEQU
CFN YES
...
DDCS loop
MG_CARD supl sh card
Configure E1/T1 ports on a Call Server
Description
Make changes to common equipment
parameters.
Common equipment.
The PRI loop number for the new DPNSS/
DASS link.
The physical card for the DPNSS/DASS loop
association to the PRI Gateway.
The format is superloop, shelf, card.
Important:
If using the NTAK93AB daughterboard, odd
card numbers are applicable (1, 3, 5, 7). If
using the onboard DPNSS/DASS, odd and
even numbers are applicable (1, 2, 3, 4, 5,
6, 7, 8).
on page 86 and
on page 87 show the D-channel interface
Table 20: PRI2/
March 2013 85