Configuring Dpnss/Dass D-Channels In The Pri Gateway Using Ld 17 - Avaya Communication Server 1000 Installation And Commissioning Manual

Configure an E1/T1 card
Use

Configuring DPNSS/DASS D-channels in the PRI Gateway using LD 17

configure the DPNSS D-channel interface in the PRI Gateway.
Configuring DPNSS/DASS D-channels in the PRI Gateway using LD 17
1. Log on to the CS 1000E.
2. To access LD 17, enter:
3. Enter the responses shown in
88 Media Gateway 1000E PRI Gateway Installation and Commissioning
Prompt Response
MG_CARD supl sh card
PORT 0 - 1
USR PRI
IFC EURO
CNTY aaaa
... ...
DCHL 0 - 254
SIDE (USR) NET
... ...
LD 17
configuration (LD 17)
Table 21: DPNSS/DASS D-channel interface configuration (LD 17)
Prompt Response
REQ CHG
TYPE ADAN
ADAN NEW DCH xx
Comments? infodev@avaya.com
MSDL= NTBK51AA/NTBK51AAE5/
NTBK51CAE5 (and later) downloadable D-
channel daughterboard.
TMDI is not supported for the PRI Gateway.
The physical card for the digital loop association
to the PRI Gateway.
The format is: superloop, shelf number, card
number.
Important:
Even card numbers are applicable (2, 4, 6,
8).
Port number of the NTBK51AA/NTBK51AAE5/
NTBK51CAE5 (and later) for the D-channel.
This D-channel is used for Primary Rate only.
Interface type for the D-channel.
Country
Loop number for the D-channel. (See PRI2 loop
number.)
The system is network/user side.
Table 21: DPNSS/DASS D-channel interface
on page 88.
Change existing data.
Action device and number.
Add a D-channel on logical port 0 - 15.
Description
on page 88 to
Description
March 2013