Pri Startup - Avaya Communication Server 1000 Installation And Commissioning Manual

Maintenance and diagnostics
Maintaining the DDCH using LD 96
1. Log on to the CS 1000E.
2. To access LD 96, enter:
3. Enter the commands shown in

PRI startup

Use Starting up the PRI
to an operational state.
Starting up the PRI
1. Check the status of all PRI/PRI2 cards.
122 Media Gateway 1000E PRI Gateway Installation and Commissioning
LD 96
96) on page 122.
Important:
In this table, x = the DCH number, and X = the MSDL address (loop shelf
card).
Table 37: DDCH maintenance commands (LD 96)
Command
DIS DCH x
ENL DCH x (FDL)
EST DCH x
RLS DCH x
RST DCH x
STAT DCH (x)
STAT MON (x)
DIS MSDL sl s c (ALL)
ENL MSDL sl s c (FDL,
ALL)
RST MSDL sl s c
STAT MSDL sl s c
(FULL)
on page 122 to take the PRI/PRI2 and DDCH from a disabled state
Comments? infodev@avaya.com
Table 37: DDCH maintenance commands (LD
Description
Disable DCH x.
Enable DCH x and attempt to establish the link, and
force download to MSDL.
Establish multiple frame operation on D-channel x.
Release D-channel x.
Reset D-channel x, inhibit signaling.
Get status of one or all D-channels.
Display the incoming and outgoing monitoring status of
one or all D-channels.
Disable DCHI card sl s c.
Enable DCHI card sl s c, with or without Force
Download.
Reset MSDL card sl s c.
Get MSDL status sl s c, or a FULL STATUS.
March 2013