To maintain the clock controller, follow
page 121.
Maintaining the clock controller using LD 60
1. Log on to the Avaya CS 1000E.
2. To access LD 60, enter:
3. Enter the commands as shown in
Maintain downloadable D-channels
D-channel commands for the DDCH/MSDL are supported for the E1/T1 card. See
the DDCH using LD 96
Media Gateway 1000E PRI Gateway Installation and Commissioning
Command
DLBK loop
Disable remote loop back test
DLBK l ch
Disable remote loop back test.
RCNT
Reset alarm counters of all DTi/PRI loops.
RCNT loop
Reset alarm counter of DTI/PRI loop.
RMST loop
Perform self-test on loop.
RMST l ch
Perform self-test on specified channel (2.0 Mb/s DTI/PRI
only.)
LD 60
60)
on page 121.
Table 36: Clock controller maintenance (LD 60)
Command
DIS CC l s
Disable system clock controller on specified superloop and
shelf.
ENL CC l s
Enable system clock controller on specified superloop and
shelf.
SSCK l s
Get status of system clock on specified superloop and shelf
TRCK aaa l s
Configure clock controller on IPMG specified by the
superloop and shelf tracking to primary, secondary or free
run, where aaa is:
PCK = track primary clock SCLK = track secondary clock
FRUN = free run mode
on page 122.
Description
Maintaining the clock controller using LD 60
Table 36: Clock controller maintenance (LD
Description
Maintain downloadable D-channels
Maintaining
March 2013
on
121