Configuring Pri2 Loops Using Ld 17; Configuring Dpnss/Dass Loops Using Ld 17 - Avaya Communication Server 1000 Installation And Commissioning Manual

Configure an E1/T1 card

Configuring PRI2 loops using LD 17

support PRI2/E1 loops (common equipment parameters) on the PRI Gateway.
Configuring PRI2 loops using LD 17
1. Log on to the Avaya CS 1000E.
2. To access LD 17, enter:
3. Enter the responses shown in

Configuring DPNSS/DASS loops using LD 17

needed to support DPNSS loops (common equipment parameters) on the PRI Gateway.
Configuring DPNSS/DASS loops using LD 17
1. Log on to the CS 1000E.
2. To access LD 17, enter:
3. Enter the responses shown in
84 Media Gateway 1000E PRI Gateway Installation and Commissioning
Prompt Response
... ...
LD 17
page 84.
Table 17: PRI2 loop configuration (LD 17)
Prompt Response
REQ CHG
TYPE CEQU
CFN YES
...
PRI2 loop
MG_CARD supl sh card
LD 17
17) on page 84.
Table 18: DPNSS/DASS loop configuration (LD 17)
Prompt Response
REQ CHG
Comments? infodev@avaya.com
Description
on page 84 describes the configuration in LD 17 to
Table 17: PRI2 loop configuration (LD 17)
Description
Change existing data.
Make changes to common equipment
parameters.
Common equipment.
Digital loop (2.0 Mb) (0 - 254)
The physical card for the PRI2 loop
association to the PRI Gateway.
The format is superloop, shelf, card.
For the PRI Gateway, card 1 to 8 is
applicable.
on page 84 shows the configuration in LD 17
Table 18: DPNSS/DASS loop configuration (LD
Description
Change existing data.
on
March 2013