Avaya Communication Server 1000 Installation And Commissioning Manual page 72

Configure the Media Gateway Controller and DSP daughterboards in a PRI Gateway
- gateway address
• The TLAN configuration of the IPMG (through Element Manager):
- IP address
- subnet mask
- default gateway address
• Information for the Call Server controlling the PRI Gateway:
- hostname of the Call Server on the ELAN subnet [optional through Element
Manager]
- IP address of the Primary Call Server
• Hostname for the PRI Gateway:
- hostname of the IPMG [optional through Element Manager]
You do not need to enter other configuration information on the MGC. All other information
necessary to the operation of the PRI Gateway is configured through Element Manager and
is automatically downloaded to the MGC from the Call Server.
After configuration is complete and the MGC has rebooted, the MGC attempts to register to
the Call Server. The Call Server then attempts to match the IP address configured in LD 97 for
this PRI Gateway against the IP address included in the registration request. If either of these
checks fail, appropriate error messages are displayed. For more information, see
Gateway Controller system alarms, events, and messages
MGC configuration information is entered two ways:
• If the MGC detects that no IP configuration exists, the setup menu appears.
• Through the mgcsetup shell command.
Important:
Any changes to the configuration of the MGC ELAN must be reflected in similar changes on
the Call Server.
Here is an example of the configuration of an MGC without any installed DSP daughterboards:
Please define the data networking parameters for this MG 1000E now.
ELAN IP : 47.11.216.79
ELAN subnet mask : 255.255.254.0
ELAN gateway IP : 47.11.216.1
Primary CS IP : 47.11.216.61
Change MGC advanced parameters? (y/[n]) : y
ELAN is set to auto negotiate, change? (y/[n]) : y
72 Media Gateway 1000E PRI Gateway Installation and Commissioning
Comments? infodev@avaya.com
on page 149.
Media
March 2013