Configure E1/T1 Ports On A Call Server - Avaya Communication Server 1000 Installation And Commissioning Manual

Configure an E1/T1 card
Section
Enable PRI spans on page 101
Initial configuration of the E1/T1
card on page 103
Access and configure an E1/T1 card
through the Web on page 110
Configure ISDN E1/T1 trunks
page 115

Configure E1/T1 ports on a Call Server

When you configure E1/T1 ports on a Call Server, you must configure:
• PRI, PRI2, and DPNSS/DASS trunk loops
• PRI, PRI2, and DPNSS/DASS D-channels
• CE-MUX clock controllers
• PRI, PRI2, and DPNSS/DASS routes
• PRI, PRI2, and DPNSS/DASS trunks
82 Media Gateway 1000E PRI Gateway Installation and Commissioning
• Enabling the NTBK51AA/NTBK51AAE5/NTBK51CAE5
daughterboard
• Enabling the NTAK93AB daughterboard
• Enabling the clock controller
• Configuring basic parameters through CLI
• Entering LAN parameters
• Verifying a network connection from the CLI
• Verifying a network connection from a PC
• Configuring basic LAN parameters by CLI
• Accessing the command line interface over the Web
page 109
• Accessing the basic parameters for the E1/T1 card through
the Web on page 110
• Adding administrative users through the Web
• Viewing and changing administrative user settings through
the Web on page 112
• Changing a password through the Web
• Configuring basic parameters for an E1/T1 card through the
Web on page 114
on
• Configuring ISDN E1/T1 trunks
Comments? infodev@avaya.com
Related procedures
on page 101
on page 102
on page 105
on page 115
on page 102
on page 103
on page 106
on page 107
on page 109
on
on page 111
on page 113
March 2013