Configure the Media Gateway Controller and DSP daughterboards in a PRI Gateway
For more information about configuring DTMF tone detection (DTR), see Avaya
Communication Server 1000E Installation and Commissioning (NN43041-310).
Configuring the Media Gateway Controller on a Call Server using LD 97
1. Log on to the Avaya CS 1000E Call Server.
2. To access LD 97, enter:
3. Enter the responses shown in
Configuring Media Gateway Controller Tone and Conference using LD 17
1. Log on to the CS 1000E Call Server.
2. To access LD 17, enter:
70
Media Gateway 1000E PRI Gateway Installation and Commissioning
LD 97
(LD 97)
on page 70.
Table 13: Media Gateway Controller configuration (LD 97)
Prompt
Response
REQ
aaa
TYPE
Supl
SUPL
0–252
SLOT
<CR>
SUPT
IPMG
The following prompts are for IPMG superloops only.
IPR0
nn.nn.nn.nn
IPMG_TYP
MGC
E
ZONE0
0-8000
DES0
...
...
DES1
...
...
Comments? infodev@avaya.com
Table 13: Media Gateway Controller configuration
Description
Request (aaa = CHG, NEW)
Superloop
Superloop number. Add prefix X to delete.
Select default.
IP Media Gateway
Shelf 0 IPMG Uplink IP address. <CR> to skip to
IPR1 when configuring new superloop; X to
remove IPR0, DES0, and ZONE0 data.
IPMG is controlled by MGC card.
Shelf 0 IPMG zone number. Zones used for
IPMG purposes must be configured as shared
so that other IP devices that are not in the same
zone can gain access to the IPMG devices.
No input, simply a header for the ELAN/TLAN
designators. This header and the ELAN/TLAN
prompts only apply to MGC-based IPMGs.
No input, simply a header for the ELAN/TLAN
designators. This header and the ELAN/TLAN
prompts only apply to MGC-based IPMGs.
March 2013