Display/Operation Mode Transition - Toshiba LC531 Series Instruction Manual

B.3 Display/Operation Mode Transition
The figure below shows mode transitions of display/operation of the loop
display.
RUN startup
FAST/SEL: ON
(hold for 1 sec or
longer)
NORMAL mode
FAST/SEL: ON
FAST/SEL: ON
SELECT mode
Figure B-2 Display mode state transition
Unified Controller nv Series Single-Loop Controller LC531/LC532 Instruction Manual
B.3 Display/Operation Mode Transition
･Alarm check
･PH/PL display
For operation, refer to "Appendix
Table B-1 NORMAL mode
operation".
FAST/SEL:OFF
･Loop display
･MV,SV operation
･Control mode operation
For operation, refer to
"Appendix Table B-1
NORMAL mode operation".
･Loop number switch
･Numerical data display
switch (MV, SV, or PV)
･Control mode operation
For operation, refer to
"Appendix Table B-2 SELECT
mode operation".
131