Operation Mode Setting Switch(Mode) - Toshiba Vm Series Instruction Manual

3.1.2 Operation mode setting switch (MODE)
The operation mode setting switches are 4-bit dip switches.
Normal operation use switch set to all OFF.
Table 3-2 shows the descriptions of the switches.
Switch
Name Function
number
1 SM Operation
mode
2 RV Reserved
3 IP0 IP address
4 IP1 type
Operation Mode
■
Normally, operation mode is set on the normal setting.
 Do not use the maintenance mode.
IP Address type
■
Vm series 1 is normally use.
Vm series 2 is for future use. Normally, please do not use this.
Tool setting is used when operating, using network parameters set from Engineering
tool.
 When changing the DIP switch settings, use a small flat-blade screwdriver, touch the tip of
the DIP switch about 2mm with the screwdriver, and move it parallel to the switch's moving
direction to turn it ON / OFF. If the DIP switch is operated while the driver is still in contact,
the switch may be damaged or deformed.
 When changing the DIP switch settings, touch the tip of the DIP switch with a screwdriver
and do not touch the metal part of the switch base. Touching the metal part of the switch
while power is on, may cause malfunction.
Table 3-2 Operation mode setting table
Off: Normal
On: For Maintenance
Not used
IP0 Off
IP1 Off
Operation Vm series 1
172.16.64.xx
Important
Note
Unified Controller Vm series TC-net 100 (TNB) Module Instruction Manual
Setting
Off On
On Off
Reserved Vm series 2
172.31.64.xx
Initial setting
(factory setting)
off
off
off
On
IP0: off
On
IP1: off
Tool
(Vm series 1
Setting
Standard Setting)
17