Chapter 4 Registration and Setting Using Engineering Tool
4.8 Registration of PUM1* Controller Using Inter-Controller
Transmission
This section describes a method to configure the nV-Tool of the PUM1*
controller in order to connect the PUM1* controller via inter-controller
transmission.
To achieve inter-controller transmission, the inter-controller transmission
variables must be declared and a program to start inter-controller transmission
needs to be created.
4.8.1
Registration of inter-controller transmission variables
The PUM1* controller has no standard inter-controller transmission variables.
The declarable types are user global and DW. Declare the inter-controller
transmission variables in a specific address according to the structure shown
below.
80
6F8C1388