Operation Mode Setting Switch (Mode) - Toshiba nv Series Instruction Manual

3.1.2 Operation mode setting switch (MODE)

The operation mode setting switches are 8-bit dip switches that determine
the operation of the EN811 module.
When the switch lever of each bit of the dip switch is turned to left (to the
ON side), it is set to ON; when it is turned to right, it is set to OFF.
Table 3-2 shows the descriptions of the switches.
Remark
• For setting, use a small slotted screwdriver.
Switch
Name Function
number
1 SM0 Operation
mode
2 SM1
3 SM2
4 RV1 Reserved
5 RV2 Reserved
6 IPF Sets IP
address to
free
7 IP0 IP address
type
8 IP1
Operation mode
Normally use the normal setting state.
◆Important
• Never use the maintenance mode.
IP address type
IP address types include Class B(factory setting), Class C, and tool setting.
Tool setting is used to use network parameters set by the engineering tool.
Table 3-2 Operation mode setting table
Setting
SM0 off on
SM1 off off
SM2 off off
Operation Normal For
maintenance
Not used
Not used
on: Free, off: Restricted
IP0 off on
IP1 off off
Opera- Class B Reserved Class C
tion 172.16.64.
xx
Unified Controller nv series Ethernet (EN811) Module Operation Manual
off
on
off
off on
on on
Tool
192.168.0.xx setting
3.1 Switch setting
Initial setting
(factory
setting)
SM0: off
SM1: off
SM2: off
(normal
setting)
off
off
off
IP0: off
IP1: off
(Class B
setting)
17