Upgrade Software Through Serial Download - Cisco 678 Installation And Operation Manual

Upgrade Software through Serial Download

Step 3
Notice to Windows 95 Users
Upgrade Software through Serial Download
Step 1
Step 2
Step 3
Step 4
Cisco 600 Series Installation and Operation Guide
3-12
Be sure that you reboot the device to activate the new image. When you log back
on to your system after the reboot, use the following command to verify the
version of the firmware that is active:
cbos# show version
Windows 95 does not have a TFTP client. If you want to utilize TFTP on a
Windows 95 system, you must install a TFTP client from a third-party vendor on
your system. One way to locate a TFTP client is to use an Internet search engine
to locate a vendor who sells a TFTP client. Some TFTP clients are provided as
share or freeware on the Internet. By request, Cisco will provide a TFTP client.
You can upgrade software on your CPE using the serial interface:
Enter the following settings through a serial console connected to your system:
38.4 Kbaud
No parity
8 data bits
1 stop bit
No flow control
To turn debug monitor on, enter:
debug monitor on
To save your changes, enter:
write
To reboot the device, enter:
reboot
After the modem reboots, press Enter twice. The prompt should change to =>.
Chapter 3 Configuration Procedures for the Cisco 627
78-11190-01