Configure For G.lite - Cisco 678 Installation And Operation Manual

Configure Line Coding (Cisco 677 and Cisco 678 only)

Configure for G.Lite

Step 1
Step 2
Step 3
Sample Output of Configuration Session for G.Lite
Cisco 600 Series Installation and Operation Guide
5-36
cbos#show version
Cisco Broadband Operating System
CBOS (tm) 025 - Release Software
Copyright (c) 1986-1999 by cisco Systems, Inc.
Compiled Dec 21 1999 20:37:27
DMT firmware version 210
NVRAM image at 0x10356930
Before the CPE can be configured for G.Lite, it must first be configured for DMT.
In addition, the central office hardware must be correctly configured to accept a
G.Lite service user.
Configure the CPE for DMT. See the "Configure for DMT" section on page 5-34.
Enter:
cbos# set interface wan0 standard g.lite
Be sure to retrain the CPE to activate the new line code. When the CPE is
retrained, use the show interface wan0 command to verify the G.Lite standard is
active.
Changes made to the running configuration must be written
Note
to NVRAM for changes to be seen on reboot.
cbos#set interface wan0 standard
SET INTERFACE WANx STANDARD requires one of the following arguments
T1.413
G.lite (G992.2)
cbos#set interface wan0 standard g.lite
Note: Change will take effect on next retrain.
Chapter 5 Configuration Procedures for the Cisco 67x CPE Devices
78-11190-01