Update the CBOS Prompt
Step 11
Update the CBOS Prompt
Step 1
Step 2
Step 3
Step 4
Set Passwords
Cisco 600 Series Installation and Operation Guide
4-8
To reboot, enter:
rb
The default Cisco 633 system prompt is
to 8 characters. You can change this prompt to a unique subscriber identifier as
shown in the following example.
Log on to CBOS using either the serial or Telnet interfaces.
To change the default prompt to 4412883 as the subscriber identifier, enter:
cbos# set prompt 4412883
4412883#
To save your changes, enter:
4412883# write
To exit CBOS, enter:
4412883# quit
After you have configured your system, you should pick new passwords for both
the enable and exec modes. Keep in mind that the enable mode provides all the
functionality of a system administrator for the CPE. Examples of good and bad
passwords are:
Good Password—77ta99y (Do not use the sample password.)
•
Bad Passwords—Passwords such as your name; or your street address, or
•
home telephone number are too predictable.
Chapter 4
Configuration Procedures for the Cisco 633
. The command prompt is limited
cbos>
78-11190-01