Chapter 4 Configuration Procedures For The Cisco; Introduction; Checklist; Table 4-1 Checklist For Configuration - Cisco 678 Installation And Operation Manual

Configuration Procedures for the
Cisco 633

Introduction

This chapter provides instructions for configuring the Cisco 633 SDSL modem.
Configuration procedures vary depending on how your Cisco 633 is configured
when shipped. You must be in enable mode to perform these configuration
procedures.
Cisco recommends that only one command-line application at a time
Note
be used to configure the Cisco 633. For example, Telnet and the
serial management interface should not be used simultaneously.

Checklist

Table 4-1
78-11190-01
Checklist for Configuration
Configuration Procedures
Log on to Cisco Broadband Operating System
Configure Interworking
Configure the Cisco 633 for Remote Management
C H A P T E R
Cisco 600 Series Installation and Operation Guide
4
Page Number
4-2
4-3
4-4
4-1