Cisco 678 Installation And Operation Manual page 67

Chapter 3 Configuration Procedures for the Cisco 627
Caution
Step 5
Sample Output of Configuration Session for DMT2
78-11190-01
Where necessary, implement the following values:
Sets the transfer mode to binary mode
-i
Downloads a file to a specified IP address
get
put Uploads a file onto that IP address
Substitute the filename for the software image update. See the latest Release
Notes for the Cisco Broadband Operating System available on CCO for the
appropriate filenames to use.
Do not turn off the power to the router until after the file transfer is
completed.
Be sure to reboot the CPE to activate the new image. When you log back in to the
CPE after the reboot, use the show version command to verify the version of the
firmware that is active. Note the DMT firmware version.
cbos#set tftp enabled
TFTP is enabled
cbos#tftp image TFTP_server_IP_address image_filename
Starting download...
Downloading in progress...... done.
Saving image...........done.
Please reboot the CPE for the new downl
cbos#reboot
Hello!
C6xx self-update code: Release 2.3.5.012
NOTE: Do not power off router until update is finished!
Decompressing router...
Erasing FLASH......
Programming...
Decompressing monitor...
Erasing FLASH.........
Programming...
Cisco 600 Series Installation and Operation Guide
Configure Line Coding
3-15