Configure For Dmt - Cisco 678 Installation And Operation Manual

Configure Line Coding (Cisco 677 and Cisco 678 only)

Configure for DMT

Step 1
Step 2
Step 3
Step 4
Cisco 600 Series Installation and Operation Guide
5-34
Verify the connection from the router to the location where the correct software
image is stored. This location is provided by your network administrator.
Typically, you use the ping command for this step.
Enable TFTP:
cbos#set tftp enabled
TFTP is enabled
Set the remote address for the TFTP host computer:
cbos # tftp remote ip address
This command tells the CPE to accept TFTP transfers from a specific IP address.
An example remote IP address would be 192.168.35.4. This address is an example
only; do not use it to configure the router.
If you do not have the CPE address, consult your network
Note
administrator.
For more information about TFTP, see
section on page
To start the file transfer from a PC, start a DOS session and enter:
C:>tftp –i CPE IP address put image_filename
Where necessary, implement the following values:
-i Sets the transfer mode to binary mode
put Uploads a file onto that IP address
To start the file transfer from a UNIX machine, enter:
root@staten-</678>tftp
tftp> mode binary
tftp> put CPE IP address:image_filename
Sent 922294 bytes in 54.9 seconds
Chapter 5 Configuration Procedures for the Cisco 67x CPE Devices
5-27.
"TFTP Server"
78-11190-01