Using Tftp From A Windows Nt Machine - Cisco 678 Installation And Operation Manual

Chapter 3 Configuration Procedures for the Cisco 627

Using TFTP from a Windows NT Machine

Step 1
Step 2
78-11190-01
The manual page for TFTP appears. The TFTP UNIX man page contains all the
information you need to establish and invoke a remote TFTP session.
Before attempting to use TFTP, make sure of the following:
On the Cisco 627, TFTP is enabled and the IP address of the ATMx port is the
•
same IP address used in Step 2 of the following procedure.
The ATMx port is enabled, and the VCI/VPI is set correctly on it.
•
The remote host computer must be configured for RFC 1483 Logical Link
•
Control (LLC)/Subnetwork Access Protocol (SNAP) encapsulation if the PC
is directly connected to the CPE through the atm0 interface, or verify the IP
connectivity between the PC and the CPE.
To use TFTP:
Start a DOS session and verify connectivity from the PC to the CPE. Enter:
IP address
C:>ping
Enter one of the following commands:
C:>tftp -i IP address put nsrouter software image filename
C:>tftp -i IP address put system configuration config filename
C:>tftp -i IP address put DSP firmware file name
where IP address is the IP address of the ATMx port.
Where necessary, implement the following options:
-i - Sets the transfer mode to binary mode.
put - Uploads a file to that IP address.
The CPE might take up to 2 minutes to upgrade the
Note
firmware. Wait until the management console reappears
before rebooting the CPE.
Using a Trivial File Transfer Protocol Server
Cisco 600 Series Installation and Operation Guide
3-11