Cisco 678 Installation And Operation Manual page 93

Chapter 5 Configuration Procedures for the Cisco 67x CPE Devices
Step 2
Step 3
Step 4
Step 5
Step 6
Step 7
Disabling PPP Routing
Step 1
Step 2
Step 3
78-11190-01
To check whether this feature is enabled, enter:
show dhcp server pool 0
Enable NAT:
set nat enabled
Reboot the Cisco 67x:
reboot
To check whether NAT is enabled, enter:
show nat
Write the changes to NVRAM:
write
Reboot the Cisco 67x:
reboot
When the Cisco 67x reboots, PPP routing is enabled.
Complete the following steps to disable the PPP routing feature for the Cisco 67x.
You must be in the enable mode.
Disable the DHCP server:
set dhcp server disabled
Disable NAT:
set nat disabled
Write the changes to NVRAM:
write
Cisco 600 Series Installation and Operation Guide
Routing Mode Procedures
5-9