Configure For Dmt2 - Cisco 678 Installation And Operation Manual

Configure Line Coding (Cisco 677 and Cisco 678 only)

Configure for DMT2

Step 1
Step 2
Step 3
Sample Output of Configuration Session for DMT2
Cisco 600 Series Installation and Operation Guide
5-38
Interleaved Symbols with CRC Errors:
No Cell Delineation Interleaved:
Header Error Check Counter Interleaved:0
Count of Severely Errored Frames:
Count of Loss of Signal Frames:
The default line coding mode for the Cisco 677 and Cisco 678 is DMT2. The
central office hardware must be correctly configured to accept a DMT2 service
user.
Configure the CPE for DMT. See the "Configure for DMT" section on page 5-34.
Enter:
cbos# set interface wan0 standard t1.413
Be sure to retrain the CPE to activate the new line code. When the CPE is
retrained, use the show interface wan0 command to verify the DMT2 standard is
active.
Changes made to the running configuration must be written
Note
NVRAM for changes to be seen on reboot.
cbos#set interface wan0 standard
SET INTERFACE WANx STANDARD requires one of the following arguments
T1.413
G.lite (G992.2)
cbos#set interface wan0 standard t1.413
Note: Change will take effect on next retrain.
cbos#set interface wan0 retrain
cbos#show interface wan0
wan0 ADSL Physical Port
Chapter 5 Configuration Procedures for the Cisco 67x CPE Devices
0
0
0
0
78-11190-01