Dhcp Server - Cisco 678 Installation And Operation Manual

Chapter 5 Configuration Procedures for the Cisco 67x CPE Devices
Step 5

DHCP Server

Note
Step 1
Step 2
Step 3
Step 4
Note
78-11190-01
Reboot the Cisco 67x:
reboot
For more information on using DHCP clients, see the set dhcp client commands
in the Cisco Broadband Operating System User Guide.
The DHCP server application automatically assigns IP addresses to DHCP clients.
To enable the DHCP server feature for the Cisco 67x.
Enabling the DHCP server automatically disables the DHCP client
on the CPE.
Enable the DHCP server:
set dhcp server enabled
To check whether this feature is enabled, enter:
show dhcp server
Write the changes to NVRAM:
write
Reboot the Cisco 67x:
reboot
The DHCP server defaults with one IP address poolcconfigured.
For more information on using DHCP servers, see the set dhcp server series of
commands in Cisco Broadband Operating System User Guide.
Cisco 600 Series Installation and Operation Guide
Configure Applications
5-19