Update The Cbos Prompt - Cisco 678 Installation And Operation Manual

Update the CBOS Prompt

Step 5
Step 6
Step 7
Step 8
Step 9
Step 10
Update the CBOS Prompt
Step 1
Step 2
Step 3
Cisco 600 Series Installation and Operation Guide
5-46
Enter:
set ppp wan0-0 ipcp 0.0.0.0
Enter:
set ppp wan0-0 dns 0.0.0.0
To enable NAT, enter:
set nat enable
To enable the DHCP server, enter:
set dhcp server enable
To save your changes, enter:
write
To reboot the CPE, enter:
reboot
The default CBOS prompt is
subscriber identifier, as shown in the following example.
Log on to CBOS using either the serial or Telnet interface. See the
section on page 5-24 for information on how to use Telnet to log on to the CBOS.
To change the default prompt to c678, enter:
set prompt c678
The prompt is limited to seven characters.
Note
The following prompt now appears:
c678#
Chapter 5 Configuration Procedures for the Cisco 67x CPE Devices
. You can change this prompt to a unique
cbos#
"Telnet"
78-11190-01