Appendix A
Connectors
Management Interface
Management Port Pinouts
78-11190-01
Figure A-7
Front View of ATM25 Connector
Pin 1
Pin 8
The management port uses an RJ-45 connector.
If you are not using a management cable ordered from Cisco, use the pinouts in
Table A-5 for the DB-9 end of the serial cable used to connect the management
port to the serial port of the PC.
Table A-5 shows the connector pinouts for the management port and the DB-9 end
of the serial cable.
Table A-5
Management Connector Pinouts
Signal
Do not connect
Do not connect
Do not connect
Ground
RJ-45-to-DB-9
Management
Serial Cable
Port (RJ-45 Pin)
(DB-9 Pin)
1
1
2
4
3
6
4
5
Cisco 600 Series Installation and Operation Guide
Rear Panel Connectors
Signal
Do not connect
Do not connect
Do not connect
Ground
A-7