Cisco 678 Installation And Operation Manual page 79

Chapter 4 Configuration Procedures for the Cisco 633
Step 4
Step 5
Step 6
Step 7
Step 8
Step 9
Attention Back-to-Back Connection Users
78-11190-01
Configure a netmask address for the WAN0-0 interface:
set int wan0-0 mask 255.255.255.0
Add a static IP route to and from the remote network. This allows data to pass
between your Cisco 633 and the remote network.
set route add ip x.x.x.x gw wan0-0
where x.x.x.x is the static IP route to and from the remote network.
You must add a static route or you will not be able to pass
Note
data.
To Telnet to the Cisco 633, enable the Telnet application:
set telnet enabled
To use the Trivial File Transfer Protocol (TFTP) to transfer files to and from the
Cisco 633, enable the TFTP application:
set tftp enabled
To save your changes, enter:
write
To reboot the CPE, enter:
reboot
The Cisco 633 is now configured for remote management. Now the FR router (for
example, a Cisco 1600) needs to be configured to pass management data. See the
following section for more information.
The back-to-back configuration between two Cisco 633 units allows one
Cisco 633 to act as CO equipment and terminate traffic initiated by another
Cisco 633.
Configure the Cisco 633 for Remote Management
Cisco 600 Series Installation and Operation Guide
4-5