Configure For G.dmt - Cisco 678 Installation And Operation Manual

Configure Line Coding (Cisco 677 and Cisco 678 only)

Configure for G.DMT

Step 1
Step 2
Sample Output of Configuration Session for G.DMT
Cisco 600 Series Installation and Operation Guide
5-40
Count of Loss of Signal Frames:
Before the CPE can be configured for G.DMT, the .full image must be loaded. See
the latest Release Notes for the Cisco Broadband Operating Sytsem for the
appropriate filenames to use. The central office hardware must be correctly
configured to accept a G.DMT service user.
Enter the following command:
cbos# set interface wan0 standard g.992.1
Be sure to retrain the CPE to activate the new line code. When the CPE is
retrained, use the show interface wan0 command to verify the G.DMT standard
is active. Note that the standard configuration for the .full image is DMT2.
Changes made to the running configuration must be written
Note
to NVRAM for changes to be seen on reboot.
cbos#set interface wan0 standard
SET INTERFACE WANx STANDARD requires one of the following arguments
T1.413
G.dmt (G992.1)
cbos#set interface wan0 standard g.992.1
Note: Change will take effect on next retrain.
cbos#show interface wan0
wan0 ADSL Physical Port
Line Trained
Actual Configuration:
Overhead Framing:
Trellis Coding:
Standard Compliance:
Downstream Data Rate:
Chapter 5 Configuration Procedures for the Cisco 67x CPE Devices
0
3
Disabled
g.992.1
8032 Kbps
78-11190-01