Power On The Cpe - Cisco 678 Installation And Operation Manual

Power On the CPE

Step 3
Step 4
Step 5
Power On the CPE
Step 1
Cisco 600 Series Installation and Operation Guide
2-18
For the Cisco 627, connect the other end of the network cable to your premises
router, for example, a Cisco 3600 series router.
For the Cisco 67x, if the customer premises has only a single Ethernet-equipped
computer, attach the Cisco 600 series CPE to the computer's Ethernet adapter
with the crossover cable provided. Otherwise, connect the Cisco 600 series CPE
Ethernet port to an Ethernet hub via a straight-through cable (not provided).
Connect the telephone cable to the WALL port. Connect the other end of the
telephone cable in the appropriate configuration as discussed in the
Configurations" section on page
(Optional step for the Cisco 678) Plug the microfilter into the PHONE port. Then
plug the telephone into the microfilter.
Never connect a telephone directly to the PHONE port of the
Note
Cisco 678; this affects the CPE's performance.
(Optional step for the Cisco 675) Plug the telephone into the PHONE port. The
telephone can be connected directly to the PHONE port of the Cisco 675 because
it uses a built-in microfilter.
Connect power to the Cisco 600 series CPE by plugging the power supply into an
appropriate electrical outlet.
Use only the Cisco-approved power supply that shipped
Note
with the CPE as your power supply.
Cisco recommends that you unplug your CPE when you are
Note
not using it.
Chapter 2
2-5.
Installation Procedures
"Possible
78-11190-01