Operation Modes; Configure Interworking - Cisco 678 Installation And Operation Manual

Chapter 4 Configuration Procedures for the Cisco 633

Operation Modes

Step 1
Step 2
Note

Configure Interworking

78-11190-01
If the CBOS version is earlier than 2.2.0, get the latest version from Cisco. See
the Trivial File Transfer Protocol (tftp) command in the Cisco Broadband
Operating System User Guide for more information on how to update the
Cisco 633 firmware. You can also update the CBOS version through the
management port also.
CBOS implements two operational modes: exec and enable. CBOS defaults to
exec mode when you log in. The exec mode grants program execution (read-only)
privileges to a user. To read or write changes to nonvolatile random-access
memory (NVRAM), you must work in enable mode. To invoke the enable mode:
At the exec mode command-line prompt, enter:
cbos> enable
Enter a password when CBOS prompts you:
cbos> enable
Password:
If you have not set any passwords for the Cisco 633, press the Enter
key when the system prompts you for a password to enter CBOS. If
you have not preset a password, you can still log on to CBOS.
You are now in enable mode. The system prompt appears:
cbos#
To translate from Frame Relay (FR) to ATM, you must first configure an IWF data
path.
Cisco 600 Series Installation and Operation Guide
Configure Interworking
4-3