Configure Static Nat - Cisco 678 Installation And Operation Manual

Chapter 5 Configuration Procedures for the Cisco 67x CPE Devices
Step 9
Step 10
Step 11

Configure Static NAT

Step 1
Step 2
78-11190-01
To program the area of memory to Flash, enter:
pb 10008000 fef00000 xxxxxxxx
where xxxxxxxx is the value recorded in Step 6.
To turn debug monitor off, enter:
m0
To reboot, enter:
rb
Prior to following these steps, contact your application vendor to find out which
ports they use.
At the command prompt of the CPE, enter:
cbos#enable
Enter:
set nat entry add inside-ip-addr inside-port outside-ip-addr
outside-port protocol
where protocol is UDP, TCP or ICMP. The default local CPE services ports are:
Service Protocol Port
Telnet TCP
TFTP UDP
SNMP UDP
Web Server TCP
23
69
161
80
Cisco 600 Series Installation and Operation Guide
Configure Static NAT
5-43