Figure 5-1 Remote System List Box - Cisco 678 Installation And Operation Manual

Chapter 5 Configuration Procedures for the Cisco 67x CPE Devices
Using Telnet to Connect to the Cisco 67x
Note
Connecting from a Windows NT 4.0 or Windows 95/98 Machine
Step 1
Step 2
Step 3
Step 4
Step 5
Step 6
Step 7
78-11190-01
Use the telnet daemon to connect to CBOS and configure and operate the
Cisco 67x.
You must have an exec password set to make a Telnet connection to
the Cisco 67x.
Click Start.
Select the Run... option.
When the Run box appears, enter telnet in the space provided.
Click OK. The Connect menu appears.
Select the Remote System... option from the Connect menu. The screen shown in
Figure 5-1 appears.
Figure 5-1 Remote System List Box
Enter the IP address of the Cisco 67x in the Host Name box and click Connect.
The system then initiates a session with the Cisco 67x. Press the Enter key three
or four times to establish a connection.
Provide the exec user password information. After the system authenticates your
password, you have access to CBOS.
Cisco 600 Series Installation and Operation Guide
Configure Applications
5-25