Configure Multiple Pcs Connected To The Cpe - Cisco 678 Installation And Operation Manual

Configure Multiple PCs Connected to the CPE

Configure Multiple PCs Connected to the CPE
Step 1
Step 2
Step 3
Step 1
Cisco 600 Series Installation and Operation Guide
5-44
For example, if the private address of your server is 10.0.0.2 and the public/routed
address assigned to your CPE is 216.160.92.4 and you are running a web server,
enter:
set nat entry add 10.0.0.2 80 216.160.92.4 80 tcp
If you are running an FTP server, enter one of the following:
set nat entry add 10.0.0.2 20 216.160.92.4 20 tcp
or
set nat entry add 10.0.0.2 21 216.160.92.4 21 tcp
After you have connected two or more PCs to the CPE (see
the CPE" section on page
start network connectivity. You can either obtain IP addresses from the CPE or
from your network administrator.
To obtain IP addresses from the CPE:
Enable DHCP (see "DHCP Client"
Select the Obtain an IP address automatically option on the TCP/IP properties on
your PC.
Restart the PC.
To obtain IP addresses from your network administrator:
Obtain the following information from the network administrator:
IP address
subnet mask
gateway
DNS server address
Chapter 5 Configuration Procedures for the Cisco 67x CPE Devices
2-13), you need to obtain an IP address for each PC to
and "DHCP
"Connect Cables to
Server").
78-11190-01