Create Routing Tables - Cisco 678 Installation And Operation Manual

Create Routing Tables

Step 2
Step 3
Step 4
Step 5
Create Routing Tables
Note
Step 1
Step 2
Step 3
Cisco 600 Series Installation and Operation Guide
5-16
To set an upstream ScalaRate for a particular VC, enter:
cbos# set interface wan0-0 rate 512
To set an upstream ScalaRate to the maximum allowable rate, enter:
cbos# set interface wan0-0 rate auto
To save your changes, enter:
cbos# write
To exit the CBOS, enter:
cbos# quit
In order to pass data through a network and onto the Internet or wide area network,
you might need to add the IP address(es) of gateway(s) to the routing table. Follow
the instructions below to build a routing table manually by adding or deleting
entries in the table.
If your Cisco 67x was provisioned to run in bridging or PPP routing
mode, you must disable both before attempting to establish routing.
To add a route and gateway to IP address 192.168.9.1, without specifying a
specific mask or metric, enter:
set route add ip 192.168.9.1 gw 192.168.10.250
To add a route and specify a netmask, gateway, or metric, enter:
set route add ip 192.168.10.0 mask 255.255.255.0
gw 192.168.245.228 metric 1
To set a default route, enter:
set route default 192.168.245.228
Chapter 5 Configuration Procedures for the Cisco 67x CPE Devices
78-11190-01