Routing Mode Procedures
Step 4
Note
Changing PPP Routing
RFC 1483 Routing
Cisco 600 Series Installation and Operation Guide
5-10
Reboot the Cisco 67x:
reboot
After you disable the PPP routing feature, you must manually
configure the Cisco 67x.
These commands change the components of PPP routing:
set dhcp server pool
•
set dhcp client -interface
•
set nat entry add
•
•
set nat entry delete
set nat timeout
•
•
set nat outside -ip
For a complete description of each of these commands, see the Cisco Broadband
Operating System User Guide.
If you disable PPP routing, see the following steps for RFC 1483 routing: from
the
"Configure the Ethernet Port (eth0)" section on page 5-11
"Evaluate System Activity and Performance" section on page
Chapter 5
Configuration Procedures for the Cisco 67x CPE Devices
through the
5-48.
78-11190-01