Start The System - Cisco ASR 1000 Series Quick Start Manual

To secure shared port adapter interface cables and input or output cables connected to the Cisco ASR 1002-X Router, follow
these steps:
Step 1 When installing the network interface cables, route the cables up to and through the cable-management bracket U
device. If you are using very thin cables that slip through the bracket openings, insert nylon cable ties through the holes
in the bracket and wrap them around the cables to secure them.
Route the excess cable out through either end of the bracket, coil it, and secure it to the rack using nylon cable ties or
Step 2
some other mode of attachment.
Step 3 It might be necessary to bundle longer cables to avoid tangling them. Do this at the cable-management bracket or at
the rack, but leave enough slack in the cables to remove a Cisco ASR 1000-ESP5 and change cables as required. Also,
do not block the power supply air vents with cables.
This completes the procedure for installing the cables in the cable-management bracket.
Proceed to the "Start the System" section on page 12
5

Start the System

Before you start the system, you must connect power to it.
Connect Power to the Cisco ASR 1002-X Router
This section provides instructions for connecting power to the Cisco ASR 1002-X Router and contains these sections with the
following power supplies:
Connecting AC Power to the Cisco ASR 1002-X Router, page 15
•
Connecting –48V DC power to the Cisco ASR 1002-X Router, page 16
•
• Connecting +24V DC Power to the Cisco ASR 1002-X Router, page 20
Read the safety warnings before you begin.
Warning The covers are an integral part of the safety design of the product. Do not operate the unit without the covers
installed. Statement 1077
Warning When you install the unit, the ground connection must always be made first and disconnected last. Statement 1046
Warning Before performing any of the following procedures, ensure that power is removed from the DC circuit. Statement
1003
Warning Only trained and qualified personnel should be allowed to install, replace, or service this equipment. Statement
1030
Warning Never install an AC power module and a DC power module in the same chassis. Statement 1050
12
to complete the installation.