ABB ACS510-01 User Manual page 45

ACS510 User's Manual
Application Macro: Alternate
This macro provides an I/O configuration adopted to a sequence of DI control
signals used when alternating the rotation direction of the drive. To enable, set the
value of parameter 9902 to 3 (
Connection example:
X1
• Analog reference (AI1)
• Start, stop and direction (DI1,2)
• Constant speed selection (DI3,4)
• Ramp pair 1/2 selection (DI5)
• Run enable (DI6)
Supplied from China by: Guangzhou Tofee Electro Mechanical Equipment Co., Ltd
Email: info@tofee.com.cn
ALTERNATE
Signal cable shield (screen)
1 SCR
External frequency reference 1: 0
2 AI1
Analog input circuit common
3 AGND
4 10 V Reference voltage 10 VDC
5 AI2 Not used
Analog input circuit common
6 AGND
Motor output speed: 0
7 AO1
8 AO2 Output current: 0
9 AGND Analog output circuit common
10 24 V Auxiliary voltage output +24 VDC
11 GND Auxiliary voltage output common
12 DCOM Digital input common for all
13 DI1
Start fwd: If DI1 state is the same as DI2, drive stops
14 DI2
Start reverse
15 DI3 Constant speed selection
16 DI4 Constant speed selection
17 DI5
Ramp pair selection: Activation selects 2nd acc/dec ramp pair
18 DI6
Run enable: Deactivation always stops the drive
19 RO1C
Relay output 1, programmable
20 RO1A Default operation:
Ready =>19 connected to 21
21 RO1B
22 RO2C
Relay output 2, programmable
23 RO2A
Default operation:
Running =>22 connected to 24
24 RO2B
25 RO3C
Relay output 3, programmable
26 RO3A
Default operation:
27 RO3B Fault (-1) =>25 connected to 27
(Fault => 25 connected to 26)
Input signals
• Analog output AO1: Speed
• Analog output AO2: Current
• Relay output 1: Ready
• Relay output 2: Running
• Relay output 3: Fault (-1)
).
...
10 V
...
20 mA
...
20 mA
1
1
Note 1. Code:
0 = open, 1 = connected
DI3 DI4
0 0
1 0
0 1
1 1
Output signals
45
Output
Reference through AI1
1 (1202)
CONSTANT SPEED
2 (1203)
CONSTANT SPEED
3 (1204)
CONSTANT SPEED
Jumper Setting
J1
...
AI1: 0 10 V
...
AI2: 0(4) 20 mA
Start-Up