ABB ACS510-01 User Manual page 30

30
Status Information
Top. The top line of the LCD display shows the basic status information of the drive.
• LOC – indicates that the drive control is local, that is, from the control panel.
• REM – indicates that the drive control is remote, such as the basic I/O (X1) or
fieldbus.
•
Rotating arrow (clockwise or counter
clockwise)
Rotating dotted blinking arrow
Stationary dotted arrow
• Upper right – shows the active reference.
Middle. Using parameter Group 34, the middle of the LCD display can be configured
to display:
• Up to three parameter values.
– By default, the display shows three parameters
0103 (OUTPUT FREQUENCY), 0104 (
0105 (
– Use parameters 3401, 3408, and 3415 to select
the parameters (from Group 01) to display.
Entering "parameter" 0100 results in no parameter displayed. For example, if
3401 = 0100 and 3415 = 0100, then only the parameter specified by 3408
appears in the Control Panel display.
– You can also scale each parameter in the display, for example, to convert the
motor speed to a display of conveyor speed. Parameters 3402...3405 scale
the parameter specified by 3401, parameters 3409...3412 scale the parameter
specified by 3408, etc.
• A bar graph rather than any of the parameter values.
– Enable bar graph displays using parameters
3404, 3411 and 3418.
Bottom. The bottom of the LCD display shows:
Lower corners – show the functions currently assigned
to the two soft keys.
Operating the Drive
LOC/REM – The very first time the drive is powered up, it is in the remote control
(REM) mode, and is controlled from the Control Terminal Block X1.
To switch to local control (LOC) and control the drive using the control panel, press
and hold the
is displayed:
Start-Up
Supplied from China by: Guangzhou Tofee Electro Mechanical Equipment Co., Ltd
Email: info@tofee.com.cn
– indicates the drive and motor rotation status as follows:
Control Panel Display
).
TORQUE
button until first, LOCAL CONTROL, or later, LOCAL, KEEP RUN,
LOC
REM
ACS510 User's Manual
Significance
• Drive is running and at setpoint
• Shaft direction is forward
Drive is running but not at setpoint.
Start command is present, but motor is not
running. E.g. start enable is missing.
),
CURRENT
or reverse