ABB ACS510-01 User Manual page 180

180
Drive Parameter
1002
*
1003
* This parameter is not available in software option +N688 and +N689.
Input Reference Select
Using the fieldbus to provide input reference to the drive requires:
• Drive parameter value set as defined below.
• Fieldbus controller supplied reference word(s) in the appropriate location. (The
location is defined by the Protocol Reference, which is protocol dependent.)
Drive Parameter
1102
1103
1106
Note! Multiple references are supported only when using the ABB Drives profile.
Scaling
Where required,
following sections, as appropriate:
• "ABB Drives Profile Technical Data"
• "Generic Profile Technical Data"
System Control
Using the fieldbus for miscellaneous drive control requires:
• Drive parameter values set as defined below.
• Fieldbus controller command(s) in the appropriate location. (The location is
defined by the Protocol Reference, which is protocol dependent.)
Drive Parameter
1601
1604
Fieldbus Adapter
Supplied from China by: Guangzhou Tofee Electro Mechanical Equipment Co., Ltd
Email: info@tofee.com.cn
Value
2 10 ( )
EXT COMM
COMMANDS
3 (
DIRECTION REQUEST
Value
1/ 2 8 ( )
EXT EXT SEL COMM
1 8 ( )
REF SEL COMM
9 ( +
COMM AI
10 ( *
COMM
2 8 ( )
REF SEL COMM
9 ( +
COMM AI
10 ( *
COMM
REFERENCES
Value
7 ( ) Run enable by fieldbus.
RUN ENABLE COMM
8 ( ) Fault reset by fieldbus.
FAULT RESET SEL COMM
Description
Start/Stop by controlled fieldbus with
Ext2 selected.
) Direction controlled by fieldbus.
Description
Ref. selected by fieldbus.
(Required only if 2 references used.)
Input reference 1 supplied by fieldbus.
1)
1)
AI
Input reference 2 supplied by fieldbus.
) (Required only if 2 references used.)
)
AI
can be scaled. See the "Reference Scaling" in the
Description
ACS510 User's Manual
Protocol
Reference
Protocol
Reference
Protocol
Reference