ABB ACS510-01 User Manual page 168

168
DCU Profile
The following tables describe the
Bit
0 READY
1 ENABLED
2 STARTED
3 RUNNING
4 ZERO_SPEED
5 ACCELERATE
6 DECELERATE
7 AT_SETPOINT
8 LIMIT
9 SUPERVISION
10 REV_REF
11 REV_ACT
12 PANEL_LOCAL
13 FIELDBUS_LOCAL 1
14 EXT2_ACT
15 FAULT
Embedded Fieldbus
Supplied from China by: Guangzhou Tofee Electro Mechanical Equipment Co., Ltd
Email: info@tofee.com.cn
STATUS WORD
DCU Profile
STATUS WORD
Name Value
1 Drive is ready to receive start command.
0 Drive is not ready.
1 External run enable signal received.
0 No external run enable signal received.
1 Drive has received start command.
0 Drive has not received start command.
1 Drive is modulating.
0 Drive is not modulating.
1 Drive is at zero speed.
0 Drive has not reached zero speed.
1 Drive is accelerating.
0 Drive is not accelerating.
1 Drive is decelerating.
0 Drive is not decelerating.
1 Drive is at setpoint.
0 Drive has not reached setpoint.
1 Operation is limited by Group 20 settings.
0 Operation is within Group 20 settings.
1 A supervised parameter (Group 32) is outside its limits.
0 All supervised parameters are within limits.
1 Drive reference is in reverse direction.
0 Drive reference is in forward direction.
1 Drive is running in reverse direction.
0 Drive is running in forward direction.
1 Control is in control panel (or PC tool) local mode.
0 Control is not in control panel local mode.
Control is in fieldbus local mode (steals control panel local).
0 Control is not in fieldbus local mode.
1 Control is in EXT2 mode.
0 Control is in EXT1 mode.
1 Drive is in a fault state.
0 Drive is not in a fault state.
ACS510 User's Manual
content for the DCU profile.
(See Parameter 0303)
Status