ABB ACS510-01 User Manual page 22

22
6. Connect the pig-tail created from the motor cable
screen to the GND terminal.
7. Strip control cable sheathing and twist the copper
screen into a pig-tail.
8. Route control cable(s) through clamp(s) and
tighten clamp(s).
9. Connect the ground screen pig-tail for digital and
analog I/O cables at X1-1. (Ground only at drive
end.)
10. Connect the ground screen pig-tail for RS485
cables at X1-28 or X1-32. (Ground only at drive
end.)
11. Strip and connect the individual control wires to
the drive terminals. See "Control Terminals Table"
on page 17.
Installation
Supplied from China by: Guangzhou Tofee Electro Mechanical Equipment Co., Ltd
Email: info@tofee.com.cn
ACS510 User's Manual
9...11
8
IP5005