ABB ACS510-01 User Manual page 13

ACS51 0 User's Manual
5. Non-English speaking locations: Add a warning sticker in the appropriate language
over the existing warning on the top of the module.
Wiring Overview
Conduit/Gland Kit
Wiring drives with the IP21 Enclosure requires a conduit/gland kit with the following
items:
• Conduit/gland box
• Five (5) cable clamps
• Screws
• Cover
The kit is included with IP21 Enclosures.
Wiring Requirements
Warning! Ensure the motor is compatible for use with the ACS510. The ACS510
must be installed by a competent person in accordance with the considerations
defined in "Preparing for Installation" on page 8. If in doubt, contact your local ABB
sales or service office.
As you install the wiring, observe the following:
• There are four sets of wiring instructions – one set for each combination of drive
enclosure type (IP21 and IP54 ), and wiring type (conduit or cable). Be sure to
select the appropriate procedure.
• Determine electro-magnetic compliance (EMC) requirements per local codes.
See "Motor Cable Requirements for CE Compliance" on page 223. In general:
– Follow local codes for cable size.
– Keep these four classes of wiring separated: input power wiring, motor wiring,
control/communications wiring, and braking unit wiring.
• When installing input power and motor wiring, refer to the following, as
appropriate:
Terminal
U1, V1, W1
PE
U2, V2, W2
• To locate input power and motor connection terminals, see "Power Connection
Diagrams" starting on page 15. For specifications on power terminals, see
"Drive's Power Connection Terminals" on page 218.
• For frame sizes R1...R4 in unsymmetrically grounded networks, see
"Unsymmetrically Grounded Networks" on page 217.
• For floating (or impedance grounded) networks, see "Floating Networks" on page
217.
Supplied from China by: Guangzhou Tofee Electro Mechanical Equipment Co., Ltd
Email: info@tofee.com.cn
Description
3-phase power supply input
Protective Ground
Power output to motor
Specifications and Notes
"Input Power Connections" on page 214.
"Ground Connections" on page 216.
"Motor Connections" on page 220.
13
Installation