Table of Contents
Advertisement
No.
Signal
16
DI_0
17
DI_1
Note
● You should refer to the table above and the label attached to the power and I/O cable to wire
the device.
● It is recommended to use the supplied 17-pin cable. The 6th, 7th, 14th, and 15th pin have been
made as RJ45 connector. The lines of other pins should be wired according to the actual
demands.
SC2000 Series Vision Sensor User Manual
I/O Signal Source
Line 0 signal line
Line 1 signal line
Opto-isolated input
Opto-isolated input
5
Description
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the SC2000 Series and is the answer not in the manual?