Rischi Residui; Residual Risks; Restrisico's; Resterende Risici - RAASM 900 Series Manual

Integral / flanged industrial pumps
Table of Contents

Advertisement

1
2
I
- Prima della messa in servizio della pom-
pa effettuare il controllo della messa a
terra (fig. 1) mediante esame visivo del
cavo e del morsetto ed eventuale misu-
ra della resistenza, in modo da garantire
la protezione contro i rischi derivanti
dall'accumulo di cariche elettrostatiche.
(Vedi anche capitolo "MESSA A TERRA",
pag. 54).
- È vietato l'uso di fiamme libere e la la-
vorazione a caldo in prossimità della
pompa.
- Non esporre pompa, raccorderia, tuba-
zioni e relativi accessori a fonti di ca-
lore e proteggerli dagli urti meccanici
prevedibili in relazione all'ambiente di
installazione.
- L'impianto elettrico e le attrezzature
elettriche installate nei pressi della
pompa devono ottemperare alle altre
disposizioni legislative vigenti nel paese
di appartenenza.

RISCHI RESIDUI

1) Tutti i modelli di pompe sono forniti
senza tubazioni e/o raccordi per il
collegamento alla rete pneumatica di
alimentazione.
Si rimanda al cap. "COLLEGAMENTO
PNEUMATICO", pag.  54, per le istru-
zioni dettagliate.
Rischio dovuto all'alta pres-
sione
Prestare attenzione in prossi-
mità dei punti di raccordo con
uno o più tubi.
NL
- Alvorens de pomp in gebruik te nemen
moet gecontroleerd worden of de aar-
ding deugdelijk is (fig. 1) door de kabel
en de klem visueel te controleren en
door de weerstand eventueel op te me-
ten om bescherming tegen de risico's
vanwege de ophoping van elektrosta-
tische ladingen te kunnen bieden. (Zie
ook hoofdstuk "AARDING", pag. 54).
- Het gebruik van open vuur en het uit-
voeren van hete bewerkingsprocessen
in de buurt van de pomp is verboden.
- Stel de pomp, de koppelingen, de slan-
gen en de toebehoren niet bloot aan
warmtebronnen en bescherm ze tegen
mechanische stoten die al naargelang
de plaats waar de pomp geïnstalleerd
wordt te voorzien zijn.
- De elektrische installatie en de elektri-
sche apparaten die in de buurt van de
pomp geïnstalleerd zijn moeten aan de
wettelijke voorschriften die in het land
waar de apparatuur opgesteld is gelden
voldoen.

RESTRISICO'S

1) Alle pompmodellen worden geleverd
zonder slangen en/of koppelingen
voor de aansluiting op het pneuma-
tische toevoernet.
Voor gedetailleerde aanwijzingen
wordt verwezen naar het hoofd-
stuk "PERSLUCHTAANSLUITING", op
blz. 54.
Risico door hoge druk
Pas op in de buurt van de ver-
bindingspunten met één of
- 28 -
GB
- Before using the pump control the
earth system (fig. 1) by visually check-
ing the cable and terminal and possi-
bly measuring the resistance, in order
to guarantee protection against risks
arising from the accumulation of elec-
trostatic charges. (See also chapter
"GROUNDING", pag. 54).
- The use of naked flames and hot work-
ing in the vicinity of the pump is pro-
hibited.
- Do not expose pump, fittings, pipes and
related accessories to heat sources; pro-
tect them from foreseeable mechanical
impacts in relation to the place of instal-
lation.
- The electrical system and electrical
equipment installed near the pump
must comply with other regulations in
force in the country.

RESIDUAL RISKS

1) All models of pumps are provided
without pipes and / or fittings for
connection to the pneumatic feeding
supply.
Please refer to chap. "PNEUMATIC
CONNECTION", page 54 for detailed
instructions.
Risk due to high pressure
Pay attention near the points
of connection with one or more
hoses.
DK
- Kontrollér jordforbindelsen, inden pum-
pen tages i brug (fig. 1). Dette sker ved
at udføre en synlig kontrol af kablet og
klemmen og eventuelt måle modstan-
den. Herved er det muligt at sikre be-
skyttelse mod risiciene som følge af ak-
kumulation af elektrostatiske ladninger.
(Se også kapitlet "JORDFORBINDELSE",
pag. 54).
- Det er forbudt at benytte åben ild og
udføre arbejdsopgaver ved høje tempe-
raturer i nærheden af pumpen.
- Udsæt ikke pumpen, koblingsudstyret,
slangerne og eventuelt tilbehør for
varmekilder, og beskyt dem mod de
mekaniske stød, der kan forventes i in-
stallationsområdet.
- Det elektriske system og de elektriske
apparater, som er installeret i nærheden
af pumpen, skal overholde de øvrige
bestemmelser i den nationale lovgiv-
ning.

RESTERENDE RISICI

1) Alle pumpemodellerne leveres uden
slanger og/eller koblinger til tilslut-
ning til trykluftsforsyningen.
Vedrørende yderligere oplysninger
henvises til kapitlet "TILSLUTNING AF
TRYKLUFT", s. 54.
Risiko pga. højt tryk
Vær opmærksom i nærheden
af koblingspunkterne med en
eller flere slanger.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents