Oil Filter - BRP CAN-AM OUTLANDER 6x6 2017 Series Operator's Manual

MAINTENANCE PROCEDURES
vmo2012-012-058_a
1. Drain plug
Allow enough time for oil to flow out of

oil filter.

Replace the oil filter. Refer to
TER
in this subsection.
Change gasket on oil drain plug.
Clean gasket area on engine and oil
drain plug then reinstall plug.
Refill engine at the proper level with
the recommended oil.
SPECIFICATIONS
Refer to
for oil capacity.
Start engine and let idle for a few min-
utes.
Ensure oil filter area and oil drain plug
areas are not leaking.
Stop engine.
Wait a while to allow oil to flow down to
crankcase then check oil level.
Refill as necessary.
Dispose of oil as per your local environ-
mental regulations.
Oil Filter
Oil Filter Removal
To reach oil filter, remove the following
parts:
– Seat
– Console
– RH side panel
– RH footrest panel.
1. Clean oil filter area.
2. Remove oil filter cover screws.
3. Remove oil filter cover.
______________
134
4. Remove oil filter.
1. Oil filter screw
OIL FIL-
2. Oil filter cover
3. O-ring
4. Oil filter
Oil Filter Installation
1. Check and clean the oil filter inlet
subsection
1. Outlet bore to the engine oil providing
2. Inlet bore from the oil pump to the oil filter
2. Install a NEW O-ring on oil filter
3. Install the filter into the cover.
4. Apply engine oil on O-ring and on
tmr2011-010-004_a
and outlet area of dirt and other con-
taminations.
tmr2011-010-005_a
system
cover.
end of filter.