Titrating Basal Rate During Infusion - CME BodyGuard 545 Color Vision Directions For Use Manual

12. Scroll using the arrow keys to the requested
protocol and confirm with
NOTE: Infusion summary screen appears showing bag volume, volume left,

infused (will be 0 (zero) if new patient was set up).
NOTE: When MediGuard

current patients weight has been exceeded than the pump wil alert
"MediGuard
NOTE: When selecting a standard pre-programmed protocol ALWAYS check

the review screen carefully to ensure the parameters match the prescription.
13. Press to deliver a loading dose if required
Press to commence infusion.
14. If auto bolus:
Press to commence infusion.
Press to delay auto-bolus.
Press to deliver a loading dose and start the
infusion.

Titrating Basal Rate During Infusion

To change Rate during the infusion, enter the new rate using the keypad and confirm by
pressing the key. Confirm again the new rate by entering the Relevant Code. The
Rate can be increased up to the "Max Titration Rate" programmed into the specific
infusion. The pump will beep to confirm acceptance of the change and the new rate will
be displayed.
NOTE: If the desired rate is above the protocol maximum range the pump will not

accept the entry and will display a message notifying the maximum rate allowed.
BodyGuard 545 Color Vision™ Directions For Use
.
is enabled and the max. rate allowable for the
TM
Limit".
TM
A:
Levobupivacaine
Bag Volume 100 mL
Vol. Remaining 100 mL
Rate 2mg/hr
Patient Bolus 3 ml
Lockout Time 15min
Protocol Limit Off
Patient Weight 60 kg
to Confirm or to Change
EPIDURAL 10:00
Start Infusion ?
Press key to start
for Loading Dose & Start
EPIDURAL 10:00
Start Auto-Bolus?
Press key to start
Press to Delay Auto-Bolus
for Loading Dose & Start
4 - Operation
- 70% █
■
- 70% █
■
44